Mitsubishi Electronics детские аксессуары Q172HCPU Руководство

PDF Руководства
454 Страницы Английский

Mitsubishi Electronics детские аксессуары Q172HCPU
Страницы
От
454
3 - 20
3 POSITIONING DEDICATED SIGNALS
2) Servo amplifier input use
(Note-3)
DOG/CHANGE signal : ON
DOG/CHANGE
DI3
DICOM
DOG/CHANGE signal : OFF
DOG/CHANGE
DI3
DICOM
MR-J3- B MR-J3- B
(Note-1): Refer to the "Q173HCPU/Q172HCPU Motion controller Programming Manual
(COMMON)" for an external signal.
(Note-2): Refer to the "Q173HCPU/Q172HCPU User’s Manual" for a pin configuration.
(Note-3): Refer to the "MR-J3-
B Servo Amplifier Instruction Manual" for a pin configuration.
(16) Servo ready signal (M2415+20n) ..............................Status signal
(a) This signal turns on when the servo amplifiers connected to each axis are in
the READY state.
(b) This signal turns off in the following cases.
• M2042 is off
• Servo amplifier is not installed
• Servo parameter is not set
• It is received the forced stop input from an external source
• Servo OFF by the servo OFF command (M3215+20n) ON
• Servo error occurs
Refer to APPENDIX 1.4 "Servo errors" for details.
Q61P Q02H
CPU
Q38B
Communication is normal
Servo ready signal : ON
M
Q172
LX
Q172H
CPU
AMP
M
AMP
POINT
When the part of multiple servo amplifiers connected to the SSCNET becomes a
servo error, only an applicable axis becomes the servo OFF state.
(17) Torque limiting signal (M2416+20n) ..........................Status signal
This signal turns on while torque limit is executed.
The signal toward the torque limiting axis turns on
Содержание
Развернуть все
Связанные руководства для Mitsubishi Electronics детские аксессуары Q172HCPU
Q173HCPU
Mitsubishi Electronics детские аксессуары Q173HCPU

Для детские аксессуары (454 Страницы)